Skip to main content

Posts

Showing posts from October, 2013

Gopur kutch part 2 (filling)

In Gopur kutch part 1 we learnt base stitch. Now lets start with filling stitch of Gopur design.


                      Part 1 of filling stitch, come out just below point 1, follow the below collage and complete part 1 filling stitch. If you observe, in part 1 filling stitch, only the areas of part 1 base stitch gets covered.













                     Click on the image, have a closer look at finished part 1 of filling stitch.


                     Part 2 of filling stitch, only the areas of part 2 base stitch gets covered.













                      Finished part 2 filling stitch.





                            Part 3 of filling stitch, come out just above point 28 in instruction chart of gopur design part 2 and just below red dot where you started your part 3 of base stitch. Observe carefully above collage and follow each step, as it is bit confusing.




               End part 3 of filling stitch exactly at staring point as shown in above picture






                     Part 4 of fill…

Gopur Kutch ( Part 1)

Gopur kutch work , lets start with this . In Ratha design,  base stitch was done in two parts. But in Gopur design base stitch has 4 parts and filling stitch also has 4 parts. This design is bit complex, so follow the instruction chart carefully.





                     Click here for design Gopur design. If you are taking printout in A4 size paper, reduce to 50% or two gopur design in one page. Always keep printout of instruction chart beside you. As usual i have taken 2 strands of thread, crewel needle 7 or 8. Copy the design on fabric.











                          In above picture you can see i have highlighted only part 1 of base stitch on fabric, beginner can follow the same, its helps you a lot and you cannot go wrong. Now follow part 1 instruction chart. Numbering shows correct path to follow and arrow mark in green colour shows intersection of two threads where exactly needle should pass under the thread.






                          Come out at point and travel to point 2 t…

Kutch Ratha Design Part 2 (filling)

Hello, in part 1 we learnt how to do base stitch of Ratha design. Now lets start with filling stitch of Ratha design. Just follow the below pictures. As usual come out just below point 1. If you observe, while doing base stitch part 1, path follows from left side of design to downwards, but here while doing filling stitch path follows from left side of design to upwards.
























                While ending try to end exactly at the starting point of filling stitch.

               Have a look at finished part 1 of filling stitch. Second part of filling stitch covers the left out area in the design.





                     High alter, watch carefully, in base stitch part 2 instruction chart, observe point 1, so just below point 1 start part 2 filling stitch as shown in picture ( orange colour thread). Come out at point 1 (little below point 1).





                       Now pass needle under the base stitch thread ( black colour in the picture).   Don't get confused, why colour ch…